Customize Voice Enterprise Options

Complete the Add a Network Policy task.

Navigate to Optional Settings CUSTOMIZE under Additional Settings in the Configure Standard Wireless Networks window.

This task is part of a series for configuring the Optional Settings for a standard wireless network. Use this task to customize Voice Enterprise options.
Note

Note

To enable Voice Enterprise or 802.11r, the SSID must be configured to use WPA2 key management.
  1. Go to Configure > Network Policies.
  2. Select an existing policy, and then select Edit.
  3. Select Next to open the Wireless Network page.
  4. Go to Additional Settings > Optional Settings, and then select CUSTOMIZE.
  5. Go to the Voice Enterprise section.
  6. Select an option.
    • Enable Voice Enterprise—Select to enable all options that are required for full voice enterprise support.
    • Custom—Select and choose one of the following options:
      • Enable 802.11k: (Radio Resource Measurement of Wireless LANs): Select to enable the devices to monitor the RF environment and network performance to help manage network usage and client roaming.
        • Enable dualband neighbor list: Select to enable APs to monitor 2.4 GHz, 5 GHz, and 6 GHz bands at the same time to widen the search for a less-loaded AP channel.
        • Max. neighbor APs: Set the maximum neighbor APs to send to the client to reduce the computational resources required for 802.11k handover.
      • Enable 802.11v: (IEEE 802.11 Wireless Network Management): Select to enable network devices and clients to share information such as location and neighbor information.
      • Enable forced disassociation: Select to enable APs to send disassociate or deauthenticate frames for a variety of reasons per 802.11v.
      • Disassociate after: (If forced disassociation is enabled.) Range: 0 to 5 seconds.
      • SNR Checking: (If forced disassociation is enabled.) Select to enable APs to consider signal-to-noise ratio to determine when to disassociate.
        • Disassociate the Client: : (If forced disassociation and SNR checking are enabled.) Select to enable APs to send disassociation frames to client devices.
        • BSSID Transition Request: (If forced disassociation and SNR checking are enabled.) Select to enable APs to send BSSID transmission management request frames to client devices.
      • SLA Checking: (If forced disassociation is enabled.) Select to enable Extreme Networks APs to consider service level agreement performance thresholds to determine when to disassociate.
        • Disassociate the Client: : (If forced disassociation and SLA checking are enabled.) Select to enable APs to send disassociation frames to client devices.
        • BSSID Transition Request: (If forced disassociation and SLA checking are enabled.) Select to enable APs to send BSSID transmission management request frames to client devices.
      • Enable 802.11r: (Fast BSS Transition): Select to optimize roaming by forcing stations to forward QoS state and encryption keys preemptively.

Continue customizing Optional Settings in the Wireless Networks configuration window. Select SAVE OPTIONAL SETTINGS to save your changes.

9038986-00 Rev AA